Configure Skybrush Server (advanced)

Skybrush is configured by default for outdoor drones. If you wish to use it for indoor drones, you need to replace its default configuration file.

The configuration file used is named skybrush.jsonc and can be found at the same place as your Skybrush Server executable (and your licence file).

A configuration file for indoor shows can be found at etc\conf\skybrush-indoor.jsonc in your skybrush-server repository, or can be downloaded from our GitHub account.

Use one of these sources to replace the default skybrush.jsonc.

Contact us for support on further configuration options as this should not be part of your setup process by default!