Fit the show to your venue

Show trajectories are always expressed in relative coordinates. To position your show in the real world, you need to define a geodetic origin and an orientation for your show (we are talking about outdoor shows here - for indoor shows the origin and the fixed orientation is usually fixed by the used positioning system).

The suggested show origin and orientation might be included in your .skyc show file, but it can be modified in Skybrush Live as well in several different ways:

  1. Right click somewhere on the map and use the context menu to place or orient your show coordinates to the given point.

  2. Move the convex hull of the trajectories around in the map with selecting it holding the left-mouse button down while navigating.

  3. Enter precise values for show orientation, origin and AMSL reference manually by clicking on the Setup environment checklist entry.

Setup environment

In the Environment settings popup window you can explicitely set the show coordinate system, the show origin and the show orientation. Furthermore, you can also choose between AGL- or AMSL- based altitude reference during the show.

Environment settings

If you use an RTK base station and you have high quality correction signals, we recommend to use absolute altitude in your flight (AMSL-based). In this case you need to setup the absolute altitude of the ground level manually.

Press the button on the right side of the AMSL reference text box to set the AMSL reference to the average absolute altitude of your active drones.

If you do not use an RTK system, relative (AGL-based) altitudes are preferred, as without RTK the AMSL values are poorly estimated and this can affect the takeoff and landing quality of your drones badly.

If you use an ArduCopter-based autopilot with EKF2, check the EK2_ALT_SOURCE parameter to setup your altitude calculation properly. With RTK, GPS altitude source is preferred, while without RTK barometer altitude source is preferred. If you use EKF3, set EK3_SRC1_POSZ instead. If you use more EKF3 lanes, also set the remaining EK3_SRCx_POSZ parameters as needed.

Finally, the Environment settings popup window can also be used to select your RTK correction data source to allow centimeter level positioning of your drones, but you can also set that up any time later on in the RTK Status toolbox item.

If you succeed with all environmental settings, yellow triangles should appear on the map, showing the newly defined home positions of the show and a yellow polygon around the home positions indicating the convex hull of all trajectories.

If you cannot see these yellow mission items, enable them from the Mission info layer in the Layers panel and/or press the Zoom to Fit button).